The effect’s controls are divided into 3 sections:
1. Character
Amount : sets the amount of the filtering applied.
Character : selects one of the pre-configured filters:
- Shrill : boosts the top frequencies enhancing the presence of the signal.
- Bright : boosts the high frequencies adding clarity and brightness.
- Tight : rolls-off the low end to reduce the muddiness of the high-gain amps.
- Flat : bypass of the filtering stage.
- Fat : boosts the middle frequencies for the best high-gain tone.
- Warm : rolls-off the high frequencies (good for taming single-coil pickups).
2. Saturation
Harmonics : sets the amount of the harmonics introduced by this stage.
Mode : selects the configuration of the stages:
- Off : bypass the saturation stage
- Tube : pre-amp stage based on a single 12AX7 triode
- Tape : simple magnetic tape model
- T-n-T : tube preamp followed by the tape model
The tape model is a very simplified one. It has only the nonlinear transfer curve and dynamic frequency response modeled.It is loosely based on the Ampex ATR-102 tape recorder.
3. Boost
Level : sets the output gain of the booster from -6dB to +24dB.
On the top of the effect’s window there are 5 more buttons:
- Enable the effect.
- Stereo mode.
- 16x oversampling.
- About.
- Check for updates
Visit: CharBooster