Menu Close

Category: Preamp

Preamplifier

preamplifier (preamp or “pre”) is an electronic amplifier that converts a weak electrical signal into an output signal strong enough to be noise-tolerant and strong enough for further processing, or for sending to a power amplifier and a loudspeaker. Without this, the final signal would be noisy or distorted. They are typically used to amplify signals from analog sensors such as microphones and pickups. Because of this, the preamplifier is often placed close to the sensor to reduce the effects of noise and interference.

californiasun_2

California Sun

California Sun is a guitar combo. Guitar Combo Amp design. 2 channels, Clean and Dirty. Level, Drive, Low and High controls. Built-in Distortion, Amp and Cabinet…

NickCrow7170Lead_3

7170 Lead

Nick Crow 7170 Lead is a tube guitar amp VST plug-in. DRIVE – Determines the amount of gain applied by the Pre Amp. LOW, MID, SWEEP, HIGH…

GimmeHead_3

Gimme Head

Gimme Head is a guitar amp head inspired by the classic tones of the 1970’s Punk movement and as such has all the attitudes already built in…

Experimental_Combo_3

Experimental Combo

7AMP Experimental Combo Emulator is a guitar amp emulation software with unusual sound.It was created to test some guitar sound processing ideas and then transformed into free…

DickHead_3

Dick Head

Dick Head is a classic hybrid guitar amp head.Dick Head is a Head ONLY so you will need to use some external cabinet modeling.

Distorque_RangeBastard_3

Rangebastard

This is an emulation of an Dallas Rangemaster with added controls for tweaking or for use as a full-range booster, an overdrive, and more.It runs in mono…

NadIR_3-1

NadIR

NadIR is a zero latency, dual Impulse Response (IR) convolver, designed to be used as a cabinet simulator for guitar and bass (pre)amplifiers.It has been designed…

CrunchDude_3

CrunchDude

CrunchDude is a very simple, yet effective guitar amplifier emulation.As the name implies, its strength lies not only in clean or over-the-top lead sounds, but especially in…

R47_2

R47

The R47 emulates a famous «rodent» pedal. It’s modeled against a schematic of the unit, and tuned against clips of the real unit. Keep in mind…